Menu
Cart 0

Conical Laser Power Probes

Conical Laser Power Probes, Reliable Laser MeasurementConical Head Power Probes are used to measure high power density CO2 laser beams which may damage the standard flat surfaced Power Probes. The conical absorbing cavity exhibits a high heat dissipation.

There are two models of Conical Power Probes: C2K, C4K and C10K. Table 1 below gives specifications for these models. Table 2 gives approximate damage threshold for both the flat surface and conical power probes.


Explanation of Damage Threshold

High power lasers that can cut metal can also damage the absorbing head of a power probe if the beam is too concentrated. It has been found that it is not possible to quote a single number for the power density that will damage a power probe. The damage threshold is also a function of the total power in the beam and whether the absorbing head is moved during the exposure.

For a CO2 laser, there is no loss in absorbtivity (no damage) when the coating is heated to the point where it exhibits a visible bleached spot but no other change. There is damage when metallic areas can be seen on the surface. In operation, power densities should be kept substantially below the indicated damage threshold.


Table 1: Conical Power Probe Specifications


Specifications

Model
C2K

Model
C4K

Model
C10K

Primary Power
Range - Watts(1)

200-2,000 (20 sec)

400-4,000 (20 sec)

1,000-10,000 (10 sec)

Alternative Power
Range - Watts

NA

NA

500-5,000 (20 sec)

Absorbing Head

Dia: 6.2cm (2.4")
Cone: 5.08cm (2")

Dia: 7.0cm (2.75")
Cone: 5.7cm (2.25")

Dia: 7.6cm (3")
Cone: 6.35cm (2.5")

Weight - gm

535

1000

1160

Accuracy

+/-5%

+/-5%

+/-5%

Repeatability

+/-1.5%

+/-1.5%

+/-1.5%



Table 2: Approximate Damage Threshold


Power
(1)
(Watts)

Time (2)
(Sec.)

Flat
Probes
(3)
(W/cm2)

Conical
Probes
(4)
(W/cm2)

100

20

10,000

15,000

200

20

7,000

11,000

500

20

4,000

8,000

1,000

20

2,500

5,000

2,000

20

1,500

3,000

5,000

20

1,100

2,200

10,000

10

900

1,800


*Moving the probe during exposure will increase (up to double) the damage threshold compared to the numbers shown for a stationary probe. To achieve this increase, the head must be moved in a circular motion so that the laser beam does not strike any one area continuously for more than 1.5 seconds.

  1. Power (watts) in a CO2 laser beam.
  2. Exposure time of the laser beam on a power probe head which is rated to accept the indicated power level.
  3. Approximate damage threshold for P500C, P1000C, P2000C, P10KC, H3C, and H4C.
  4. Approximate damage threshold for C2K, C4K and C10K conical power probes.
... ...